Installation and debugging of reverse osmosis pure water equipment

Reverse osmosis pure water equipment is applied in many fields, such as fine chemical industry, biopharmaceutical, food and beverage industry, electronic semiconductor, boiler water, etc. However, many units or individual customers do not know how to use or install and debug this type of equipment because it is their first purchase. Today, we will provide a detailed introduction to the next operating steps.

Specific steps for installation and operation of reverse osmosis pure water equipment

1. Install filter materials such as quartz sand, activated carbon, and softened resin.

2. Place the reverse osmosis pure water host and preprocessor near the water source and power supply.

3. Connect the water pipeline: the inlet of the raw water pump is connected to the water source, the outlet of the pre filter is connected to the inlet of the host, and the pre processor and host drainage ports are connected to the sewer through pipelines.

4. Circuit: Firstly, ground the grounding wire and connect the randomly equipped power cord to the electrical control box in the room.

5. Connect the water source and power supply, follow the requirements of the "Pre treatment Operation Instructions" and follow the steps to complete the pre treatment debugging operation.

6. When using this machine, turn the raw water pump switch to the automatic position and unscrew the shutdown switch. Connect the water source and power supply, and wait until the pressure at the multi-stage pump port reaches the set value of the pressure controller

When the multi-stage pump starts working. After the multistage pump is started, adjust the system pressure to 1 The R0 membrane system should be manually rinsed for 30 minutes during the initial start-up of 0-2Mpao.

Debugging of reverse osmosis water purification equipment

1. Check whether the connections between all pipelines of the device are complete, whether the pressure gauge is complete, whether the low-pressure pipeline connections are tight, and whether there is a shortage.

2. Analyze and test the inlet water of the reverse osmosis purified water equipment, and the results show that it meets the inlet water requirements before proceeding with water commissioning of the device.

3. Adjust the pressure control system of the high-pressure pump.

4. Fully open the pressure gauge switches, main inlet valve, concentrated water discharge valve, and produced water discharge valve of the reverse osmosis purified water equipment.

The above is what Hongjie Water brings to you about the installation and debugging of reverse osmosis pure water equipment. We hope it can help you!

Shenzhen Hongjie Water Technology Co., Ltd. is an integrated high-tech enterprise specializing in product research and development, production, sales, engineering design, installation and debugging, technical consulting, and sales of supporting materials in the fields of industrial water treatment and drinking water treatment. Our main products include the design, manufacturing, installation, debugging, and maintenance of water treatment equipment, including pure water equipment, ultra pure water equipment, reverse osmosis equipment, GMP purified water equipment, EDI deionized water equipment, domestic sewage equipment, industrial wastewater equipment, softened water equipment, and reclaimed water reuse equipment, all of which are integrated into an environmentally friendly high-tech manufacturer.